Updating Your Atem Mini; Configure Page - Blackmagic Design ATEM Mini Manual De Instalación Y Funcionamiento

Updating your ATEM Mini

To update your ATEM Mini, simply connect the unit to your computer via USB or Ethernet.
Launch ATEM Setup. If the software version installed on your computer is newer than the
version installed on your ATEM Mini, a dialogue box will appear notifying you of an update.
Simply click on the 'update' button and follow the prompts to update the unit.
A progress bar will appear with a notification to let you know when the update is complete.

Configure Page

Panel Settings
Switching Mode
This setting lets you set ATEM Mini to use program preview or cut bus switching modes. Refer
to the 'Switching Modes' section for more information.
Picture in Picture Keyer
This setting lets you choose to keep the picture in picture on screen indefinitely so you can
switch content underneath it, or tie it to the next transition so when you perform the transition,
picture in picture will transition off screen with it.
‚ Drop with Transition
Ties picture in picture to the next transition and will transition off screen when the next
transition is performed.
‚ Stay on with transition
Holds picture in picture on air so you can switch sources without affecting picture
in picture.
TIP Drop with transition lets you smoothly turn off picture in picture by linking it
with the transition, however you can always turn picture in picture off at any time
by pressing the respective off button on the control panel.
Chroma Keyer
These settings are similar to the picture in picture keyer setting, however it applies to the
upstream keyer.
‚ Drop with Transition
Ties the upstream chroma keyer to the next transition and will transition off screen
when the next transition is performed.
‚ Stay on with transition
Holds the upstream chroma keyer on air so you can switch sources without affecting
the chroma key.
About Page
The about page tells you which version of ATEM software is installed on your computer.
To change the name of your ATEM Mini, click in the 'label' edit box, type in a new name and
click 'save'
ATEM Mini Setup Settings 57