Homelite HCS3335A Manual De Utilización página 50

EN
FR DE ES IT PT
PROBLEM
Bar and chain running hot
and smoking.
Engine starts and runs, but
chain is not rotating.
960390004-05.indd Sec1:47 960390004-05.indd Sec1:47
NL SV DA NO FI HU CS RU
English(original instructions)
POSSIBLE CAUSE
Chain lubricant tank empty.
Chain tension is too tight.
Oiler is not functioning.
Chain brake is engaged.
Chain tension is too tight.
Guide bar and chain assembled
incorrectly.
Guide bar and/or chain are
damaged.
Drive sprocket teeth damaged
47
RO PL SL HR ET
SOLUTION
Lubricant tank should be filled every time fuel tank
is filled.
Tension chain per instructions in Adjusting the
Chain Tension in the Maintenance section of this
manual.
Run at half throttle 30 to 45 seconds. Stop saw
and check for lubricant dripping from guide bar.
If lubricant is present, the chain may be dull or
bar may be damaged. If no lubricant is present
contact an authorised service centre.
Release chain brake. Refer to Operating the
Chain Brake in the Operation section of this
manual.
Tension chain per instructions in Adjusting the
Chain Tension in the Maintenance section of this
manual.
Refer to Replacing the Guide Bar and Chain in
the Maintenance section of this manual.
Inspect guide bar and chain for damage.
Contact an authorised service centre for drive
sprocket replacement.
LT LV SK BG
22/02/2010 4:06 PM 22/02/2010 4:06 PM