1 Introduction and Safety
1.1 Introduction
Purpose of this manual
The purpose of this manual is to provide necessary information for:
• Installation
• Operation
• Maintenance
CAUTION:
Read this manual carefully before installing and using the
product. Improper use of the product can cause personal in-
jury and damage to property, and may void the warranty.
NOTICE:
Save this manual for future reference, and keep it readily available at
the location of the unit.
1.1.1 Inexperienced users
WARNING:
This product is intended to be operated by qualified person-
nel only.
Be aware of the following precautions:
• Persons with diminished capacities should not operate the prod-
uct unless they are supervised or have been properly trained by a
professional.
• Children must be supervised to ensure that they do not play on or
around the product.
1.2 Safety terminology and symbols
About safety messages
It is extremely important that you read, understand, and follow the
safety messages and regulations carefully before handling the product.
They are published to help prevent these hazards:
• Personal accidents and health problems
• Damage to the product
• Product malfunction
Hazard levels
Hazard level
DANGER:
WARNING:
CAUTION:
NOTICE:
Hazard categories
Hazard categories can either fall under hazard levels or let specific
symbols replace the ordinary hazard level symbols.
Electrical hazards are indicated by the following specific symbol:
Electrical Hazard:
These are examples of other categories that can occur. They fall under
the ordinary hazard levels and may use complementing symbols:
• Crush hazard
• Cutting hazard
• Arc flash hazard
Hot surface hazard
Hot surface hazards are indicated by a specific symbol that replaces
the typical hazard level symbols:
ATEX e-SV Installation, Operation, and Maintenance Manual
Indication
A hazardous situation which, if not
avoided, will result in death or se-
rious injury
A hazardous situation which, if not
avoided, could result in death or
serious injury
A hazardous situation which, if not
avoided, could result in minor or
moderate injury
• A potential situation which, if
not avoided, could result in
undesirable conditions
• A practice not related to per-
sonal injury
en - Translation of the original instructions
CAUTION:
Description of user and installer symbols
Specific information for personnel in charge of installing
the product in the system (plumbing and/or electrical
aspects) or in charge of maintenance.
Specific information for users of the product.
1.3 Disposal of packaging and product
Observe the local regulations and codes in force regarding sorted
waste disposal.
1.4 Warranty
For information about warranty, see the sales contract.
1.5 Spare parts
WARNING:
Only use original spare parts to replace any worn or faulty
components. The use of unsuitable spare parts may cause
malfunctions, damage, and injuries as well as void the guar-
antee.
CAUTION:
Always specify the exact product type and part number
when requesting technical information or spare parts from
the Sales and Service Department.
1.6 EC DECLARATION OF CONFORMITY
(TRANSLATION)
LOWARA SRL UNIPERSONALE, WITH HEADQUARTERS IN VIA
VITTORIO LOMBARDI 14 - 36075 MONTECCHIO MAGGIORE VI -
ITALY, HEREBY DECLARES THAT THE PRODUCT:
ELECTRIC PUMP UNIT (SEE LABEL ON FIRST PAGE)
MARKED
II 2 G c II B T4
FULFILS THE RELEVANT PROVISIONS OF THE FOLLOWING EU-
ROPEAN DIRECTIVES:
• ATEX 94/9/EC
• MACHINERY 2006/42/EC (ANNEX II: THE TECHNICAL FILE IS
AVAILABLE FROM LOWARA SRL UNIPERSONALE)
• ECODESIGN 2009/125/EC, REGULATION (EU) No. 547/2012
(PUMP) IF MEI MARKED
AND THE FOLLOWING TECHNICAL STANDARDS
• EN 1127-1, EN 13463-1, EN 13463-5
• EN 809
CONCERNING THE ELECTRIC MOTOR, REFER TO MANUFAC-
TURER'S EC DECLARATION OF CONFORMITY AND INSTRUC-
TIONS MANUAL, INCLUDED IN THE SUPPLY.
PUMP (SEE LABEL ON THE FIRST PAGE)
MARKED
II 2 G c II B T4
FULFILS THE RELEVANT PROVISIONS OF THE FOLLOWING EU-
ROPEAN DIRECTIVES:
• ATEX 94/9/EC
• MACHINERY 2006/42/EC (ANNEX II: THE TECHNICAL FILE IS
AVAILABLE FROM LOWARA SRL UNIPERSONALE)
• ECODESIGN 2009/125/EC, REGULATION (EU) No. 547/2012
(PUMP) IF MEI MARKED
AND THE FOLLOWING TECHNICAL STANDARDS
• EN 1127-1, EN 13463-1, EN 13463-5
• EN 809
NOTIFY BODY WHICH RETAINS COPY OF THE TECHNICAL FILE:
SGS BASEEFA LTD.
ROCKHEAD BUSINESS PARK, STADEN LANE
BUXTON, DERBYSHIRE, SK17 9RZ
ENGLAND
(BODY IDENTIFICATION NUMBER: NB 1180)
0°C ≤ Tamb ≤ 40°C
0°C ≤ Tamb ≤ 40°C
13