Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
5.
TRANSPORT AND STORAGE
5.1.
General Information
The equipment must be transported and handled
using appropriate means with adequate capacity.
!
During transport and
handling
equipment, it is strictly
forbidden to stack one
machine on top of the
GB
other, in order to exclude
the risk of loads tipping
over due to stacking.
5.2.
Transport and Handling
!
It is forbidden to stand under suspended
loads during handling and transport. Unauthorised
personnel may not enter the work area. The
transported
accelerating, cornering and on rough roads.
!
The equipment must be handled in a vertical
position. It is forbidden to move the equipment in a
horizontal position. If the equipment is handled in a
horizontal position, wait a few hours before
operating it.
For the correct performance of lifting operations,
use the most suitable type of equipment in terms of
characteristics and load capacity: forklift or
transpallet.
5.3.
Storage
!
The equipment must be stored in a non-
aggressive, vibration-free environment.
The room temperature should be between -
10°C and +50°C. Avoid excessively humid
environments. The storage place must have an
6.
INSTALLATION
6.1.
Packaging And Unpacking
Handle and install the appliance respecting the
information provided by the manufacturer, shown
directly on the packaging, on the appliance and in
this manual.
of
the
load
can
move
when
The equipment must only be transported,
handled and stored by skilled staff.
Minimum requirements for skilled staff are as
follows:
•
specific technical training and experience in
the use of lifting systems;
•
knowledge
applicable laws;
•
knowledge of general safety requirements;
•
respect for the use of personal protective
equipment in accordance with the operation
performed;
•
the ability to identify in advance and avoid any
possible danger.
!
Avoid pushing or dragging the equipment
when handling it.
Before lifting, secure the surrounding area
braking,
and prevent access to personnel. Move the
equipment to a minimum height above the ground
and ensure the stability of the load.
!
Do not lift the equipment in any other way
than explained in this manual.
Before placing the load, check that the floor is level
and has sufficient load-bearing capacity to support
the weight of the load.
adequate support surface to prevent deformation of
the machine or damage to the support feet.
!
Only skilled staff is allowed to perform
positioning, assembly and disassembly of the
equipment.
Wear protective gloves before unpacking.
10
of
safety
regulations
and
Publicidad
