Descargar Imprimir esta página

Alpinestars TECH-AIR OFF-ROAD Manual Del Usuario página 41

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 306
Figure 25: How to detach the Removable Inflators Housing (18) from the System by pulling it up
Now it's time to remove all the non-washable and electronic components as reported in
Figure 26 .
First, we need to open the Electronic Connector Plug (22) by holding the lower part of the
plug connected to the ECU and gently pushing on the tiny square button, with your right
hand, while simultaneously with your left hand the User needs to pull so that the connector
opens. Now the User will be able to completely remove the Airbag from the System, as the
clips have already been detached. The User can do this by extracting the Airbag together
with the Gas Inflators (17) and all the Electronic components (13-15-19) from the upper
opening of the back protector).
The User may start to gently pull the entire Airbag out of the Tech-Air
System, until it is
®
completely removed. Next, the User must remove the LED Display (4) from its location.
Now, turn the System on its back with the back protector facing downwards. Put your hand
into the System from the opening under the inner lining on the left chest of the System.
Bring your hand up to the loop on the right shoulder and remove the Electronic Connector
cable plug by pulling it out through the loop. Next open the Velcro pocket on the left chest
so you can access the Haptic Vibration Area (3). The User must now remove the Activation
Zip Sensor from the pocket. Next, the User must pull the cable down through the Haptic
Vibration Area (3) access hole
on the left side until the entire cable has been removed
(see reference in Figure 28). Next the User must open the Velcro found on the left wing
of the chest protector and remove the LED Display (4). At this point, all of the Electronic
components (13-15-19) should have now been completely removed from the System.
42 EN

Publicidad

loading