Descargar Imprimir esta página

Alpinestars TECH-AIR OFF-ROAD Manual Del Usuario página 62

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 306
The protector integrated into the System is a Level 1 passive full back protector.
The following table summarizes and explains the performance level reported on the product
marking as a passive impact protector:
Standard
Used for
Tests
Tested Area
method
applied in
tests
EN 1621-
Full Back
2:2014
WARNING!
Always before any use, check the back protector for any damage to
any part of it. Regardless of the age, do not use the system if you
notice any damage and/or degradation of the back protector.
WARNING!
Any contamination, alteration of the back protector or improper use
can dangerously reduce the performance of the back protector.
Sizing & fitting information regarding the back protector integrated onto the
System
Back protectors are certified to EN 1621-2:2014 are sized by 'Waist to Shoulder length,' as
this gives the best representation of back length. Waist-to-shoulder length is the length
measured on the back from the waistline to the junction of the shoulder to the neck at the
highest point, as shown in the protective equipment pictogram.
The System is equipped with an integrated back protector that is not removable from the
airbag vest nor may the back protector be modified.
The size of the back protector has been selected by Alpinestars based on the sizing and
function of the System. Notwithstanding one single size back protector cannot fit all body
dimensions (height and shape). Accordingly, when selecting the System check that the
System's integrated back protector is correctly fitting. A correctly fitting back protector
Force
Transmitted
with Impact
Energy
Temperature
of
50 Joule
Value
Average/
Maximum
Average ≤ 18kN
23°, -10°, 40°
Peak ≤ 24kN
Level
Level 1 requirements:
average value ≤ 18kN; No
impact above 24kN
Level 2 requirements:
average value ≤ 9kN; No
impacts above 12kN
Level 1
63 EN

Publicidad

loading