Alpinestars TECH-AIR OFF-ROAD Manual Del Usuario página 43

16.2.4 REASSEMBLY OF THE SYSTEM
After cleaning the washable components, the User MUST proceed with the correct
reassembly of the System following the instructions below:
1. First, place the System with the Back Protector facing up. The User must reinsert the
Airbag through the opening in the Back Protector, taking care to position the Airbag
correctly (it is critical that the User avoid twisting or creating folds of the Airbag). Insert the
Airbag inside the System with the utmost attention to ensure that each clip is meticulously
matched by color and number to the exact corresponding Connection Clip inside the
System. The User MUST anchor the Airbag on ALL 10 of the Connection Clips as shown
in Figure 28. It is suggested to do this operation with the Gas Inflators (17) positioned in
the corresponding Removable Inflators Housing (18). In order to attach the Airbag to the
corresponding Connection clips, the User should use the front Base Layer (5) openings by
matching the numbered and coloured labels on both the Airbag and on the System's Base
Layer (5), (see Figure 28). Please notice that Connection Clips 4 and 10 have double coloured
blue and red labels, (make sure when attaching the Connection Clips that the red side is
matched to the red side and the blue side is matched to the blue side), in order to help the
User to attach the Airbag in the correct orientation.
WARNING! The lower Back Clips (1 and 2) have to be attached in a criss-cross
fashion, as reported in the figure 24 below, making an x on the back
of the Airbag, this ensures that the Airbag is well anchored. The lower
Back Clips (1 and 2) will therefore be attached to the opposite clips
with respect to the back view, and as a result the Users should see a
slightly folding of the bottom borders of the Airbag. Referring to the
frontal view, clip 1 MUST be attached to the left clip and clip 2 MUST
be attached to the right clip, as reported in Figure 28.
2
1
44 EN
2
Figure 24
2
1
1