Alpinestars TECH-AIR OFF-ROAD Manual Del Usuario página 42

At this stage, the User will now be able to safely clean the System following the
indications reported in Section 16.2.3 below.
Figure 26: How to remove all the non-washable System's components from the back of the System
16.2.3 CLEAN WASHABLE COMPONENTS
After ALL the steps indicated in Sections 16.2.1 and 16.2.2 above have been performed, the
User MUST now have ONLY the washable parts attached to the System which include: the
fabric Base Layer (5) along with the Chest (7) and Back Protectors (11). At this point the User
MUST have ONLY fabric and plastic parts still hooked up to the System.
The User can now clean the remaining washable parts by ONLY HAND-WASHING them (30
°C). Under NO circumstances should the User put the remaining washable components
into a washing machine. Under NO circumstances completely submerge all the remaining
parts in water. The User can submerge in water and soap ONLY the textile parts and cannot
use any chemical solvent or cleaner. Use only a damp cloth with soap and dry the garment
afterwards using a towel or allow it to dry naturally.
WARNING! Only detach the Airbag to wash the Base Layer (5). The Airbag is a very
critical safety part of Tech-Air
caution when handling the Airbag. Any scratches, holes, or damage to
the Airbag will lead to the System's malfunction, accordingly, if you
see any such damage to the Airbag do not use the System and send
the System to Alpinestars or to an authorized Alpinestars' Tech-Air
Service Center for service.
Off-Road System. Always use extreme
®
®
43 EN