Descargar Imprimir esta página

Alpinestars TECH-AIR OFF-ROAD Manual Del Usuario página 65

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 306
body providing discomfort whilst riding and limiting the effectiveness of wearing a Chest
Protector. If the Chest Protector is too small, it will move inside the protector pocket(s)
not ensuring a sufficient protection of your chest area. Check that the Tech-Air
System and its integrated chest protector is positioned correctly on the upper portion of
your chest and not stomach. The chest protector should not be so wide so as to affect your
arm movements when in your normal riding posture.
The following table explains and summarize passive chest protectors sizes already installed
in your vest:
Base Layer Size
International Size MAN
S
42-44
M
46-48
L
50-52
XL
54-56
2XL
58-60
Motorcyclists' protective clothing against mechanical impact general information
CARE & STORAGE
The protectors can be cleaned with a damp cloth and soapy water. Do not submerge the
protectors in water. Never clean the protector with strong cleaning agents or solvents as
these could weaken the materials or damage the integrity of the protector. Care must be
taken to avoid bending the protectors, particularly during storage. Store the protectors
in a dry ventilated area away from direct heat sources, including direct sunlight. Do not
place heavy objects on top of the protectors. Extract the protectors from the garment
to facilitate cleaning. Make sure that all of the removable protectors have been reinserted
into the garment before riding with the garment again. DO NOT USE the garment if the
removable protectors have not been reinserted into the garment or are missing. Using the
garment without the removable protectors will render the CE and UKCA certification invalid
and moreover provide no protection against impacts.
WARNING!
Remember that for sensible motorcycling the full body must be
protected and as such the protector should be worn with correctly CE
and UKCA certified and fitting motorcycle clothing, boots, gloves and
an homologated helmet.
MAINTENANCE
The protectors should be periodically inspected for wear and tear. Depending on the location
of the protectors in the garment, this may require that the protectors be removed from
66 EN
Chest protector size
Type A
Type A
Type A
Type B
Type B
Off-Road
®

Publicidad

loading