Jar Cycle Run With The Container Inside The Vacuum Chamber - Orved Сuisson 31 Manual De Uso

OPERATION

9.7.2 jAR CyClE RUN WITh ThE CONTAINER INSIDE ThE VACUUM ChAMbER

This mode is possible with the table models that have the optional external connection with shut-off valve. Proceed as
follows:
1) Tighten the rubber holder fitting
2) Apply the suction device
A
in the fitting .
3) Select the desired containers program and program the duration of the vacuum (SENSOR jARS):
PhASE DESCRIPTION
1 Enter "containers program" mode "by pressing the PUMP key.
2 Select one of the seven programs for containers with the SEl selection key.
Programming of time for SENSOR JARS: enter the programming mode by pressing
3
PROG for 3 seconds. The display shows the programmed value.
4
Change the value. A number of LEDs proportional to the value switch on/off.
5 Confirm the value with PROG.
4) Start-up the cycle by lowering the lid. Wait until the vacuum gauge
bar) and open the valve
the container.
6) At end of cycle close the valve
E
Close the valve of the vacuum container lid immediately.
E
A
OPEN
ClOSED
b
52
Rev. 01 - 03/2018 - Cod. 1500024 - Instruction manual for vacuum chamber packaging machines for vacuum cooking mod.
A
on the attachment. Make sure the valve
C
to the rubber holder fitting
b C
. Press the device
b
and remove the device
f
A
and push the pipe
D
indicates the maximum vacuum value (-1.0
firmly on to the lid until sufficient depression has been created in
C
by tilting it sideways.
6) Interruption of the cycle: by pressing the "STOP" key at
any time, the machine immediately stops the cycle and the
chamber is decompressed.
7) The jars function remains active: to exit the mode, press
the "PUMP" key again.
C
D
b
is in the closed position.
f
of the device as far as possible
KEy
Cuisson