Orved Сuisson 31 Manual De Uso página 86

TROUblEShOOTING
PROblEM
The machine does not seal.
Poor sealing.
gas quantity in bags insufficient.
lid opens during GAS cycle.
Vacuum not created in containers. • Cover not placed correctly.
Deaeration Alarm Display.
Vacuum Sensor Alarm Display.
Gas Alarm Display.
Oil Alarm display.
Sealing Alarm display.
Overheating Alarm display.
86
Rev. 01 - 03/2018 - Cod. 1500024 - Instruction manual for vacuum chamber packaging machines for vacuum cooking mod.
POSSIblE CAUSES
• Dirty welding bar contacts.
• Discontinued welding bar contacts. • Restore connection (contact your service centre).
• Sealing bar wire broken.
• Sealing bar fuse blown.
• Seal bag perforated.
• Sealing bar dirty.
• Sealing time insufficient for basic
bag weight.
• Teflon cover worn.
• Gas percentage is too high (close to
70%) with respect to the packaged
product.
• Silicone worn.
• Gas flushing time insufficient.
• Gas cylinder pressure Insufficient.
• Gas nozzle not inserted in bag
mouth.
• Cylinder valve or pressure reducer
closed.
• Gas percentage too high.
• Product with high liquid part
packed at an excessively high tem-
perature.
• Lid seal leaking or leakage in the
vacuum circuit.
• Vacuum sensor disconnected,
blocked or damaged.
• Gas canister empty, gas regula-
tor valve closed, blockage of the
connection pipe.
• Reaching of the maximum thresh-
old of cycles that can be performed
before the oil change.
• Electrical failure of the sealing bar
(faulty fuse or electrical contact).
• Overheating of the pump or of the
sealing bar.
SOlUTION
• Clean contacts.
• Change wire. (Contact a Service Centre).
• Change PF2 fuse on power board.
• Change seal bag.
• Clean sealing bar.
• Increase sealing time using "SEAL" parameter.
• Change Teflon cover.
• Reduce gas percentage.
• Change silicone.
• Increase gas percentage using "GAS" key.
• Adjust pressure on cylinder reducer to 1 bar.
• Reposition bag by inserting gas nozzle in the bag
mouth.
• Open cylinder valves and adjust pressure reducer
to 1.0 bar.
• Decrease the percentage of gas by changing the
"GAS" parameter
• Reposition then create vacuum by pressing slightly
on the lid.
• Reduce the temperature of the product.
• Contact the service centre
• Work with one of the 20 user programs and contact
the service centre.
• Restore the gas flow.
• Check the condition of the oil; where necessary
change the pump oil (contact the service centre).
• Contact the service centre
• Allow the machine to cool. If upon restart, the alarm
recurs, contact the service centre.
Cuisson