Merrithew PROFESSIONAL Serie Instrucciones De Uso página 10

REFORMER FEATURES
Setting Up the Vertical Frame
Ensure spring clips are fully closed at both ends of springs. A spring clip that is only partly closed risks detaching with high force
CAUTION:
Push-Thru Bar, Springs from Below
CAUTION: THE SAFETY CHAIN MUST BE ATTACHED WHEN USING
THE PUSH-THRU BAR WITH SPRINGS FROM BELOW.
When using the push-thru bar with springs from below, attach
springs to eyehooks on lowest eyehooks on vertical frame using
locking spring clips. Then attach one or two springs to eyehooks
on lower side of bar, ensuring spring clips are completely closed
and secure.
A TRAINED PROFESSIONAL MUST KEEP A HAND ON THE BAR
AT ALL TIMES AND SAFETY CHAIN MUST BE USED.
Push-Thru Bar, Springs from Above
CAUTION: To prevent accidental injury, never put your face
(or another body part) above the push-thru or roll-down bar
while spotting an exercise.
When performing exercises that require the spring resistance
to come from above the bar, attach the push-thru spring to the
eyehook on the upper side of the push-thru bar with the locking
spring clip. Attach the other end of the push-thru spring with the
spring clip to one of the eyehooks on the vertical frame.
A trained professional must keep a hand on the push-thru
bar for any exercises with the springs attached from above. Locking
spring clips must be used to attach push-thru springs from below to
the vertical frame.
10 REFORMER INFORMATION FOR USE
safety chain
Adjustable Pulley System
The spring-loaded track system provides
MAX PLUS ONLY:
adjustability for pulleys and spring hooks throughout the range
of the vertical frame.
Altering Height of Traveling Pulleys and
Traveling Spring Hooks
Pull out the spring-loaded stopper on traveling pulley.
w
Shift traveling pulley up or down the track and release the
w
spring-loaded stopper. The pulley will spring-lock into the nearest
stopper position.
Shake traveling pulley to confirm it is fully locked into stopper
w
position.
The same method applies to adjusting traveling spring hooks.
w
Adjust rope length as necessary
w
Prior to use, confirm that the traveling pulley system is in
CAUTION:
good order and that the threaded bolts or the traveling pulleys are
securely fastened.
Roll-Down Bar
Attach roll-down springs to roll-down bar, then to the fixed
eyehooks at the top of the vertical frame (see page 7). Both springs
must be attached. To decrease or increase, spring tension, substitute
light arm springs or leg springs respectively. Make sure spring clips
are completely closed and secure.
CAUTION: Roll-down bar can release at high velocity due to
spring tension. Ensure a secure grip at ALL times. Gripper mats are
recommended.