Siemens SINAMICS S120 Manual De Listas página 2414

n_ctrl config
p1400[D]
<1> Only for VECTOR.
1 2
DO: VECTOR, VECTOR3P, VECTORGL, VECTORM2C, VECTORSL
Vector control - Speed control configuration
Speed control configuration
Bit No. Meaning
0 1 = Automatic Kp/Tn adaptation active
1 1 = Sensorless vector control, freeze I component
2 Acceleration pre-control, signal source: 1 = External (p1495) , 0 = Internal (n_set)
3 Reference model speed setpoint, I component: 1 = ON, 0 = OFF
4 Reserved
5 1 = Kp/Tn adaptation active
6 1 = Free Tn adaptation active
7 1 = Interpolation speed pre-control active
8 Reserved
9 Reserved
10 1 = Speed pre-control active
11 Reserved
12 Reserved
13 Reserved
14 Torque pre-control: 1 = Always active, 0 = For n_ctrl enabled
15 1 = Sensorless vector control, speed pre-control active
16 I component for limiting: 1 = Enable, 0 = Hold
17 Reserved
18 1 = Moment of inertia estimator active
19 1 = Anti-windup for integral component active
20 Acceleration model: 1 = ON, 0 = OFF
21 Reserved
22 1 = Obtain moment of inertia estimator value for pulse inhibit
23 1 = Acceleration model (with speed encoder)
24 1 = Moment of inertia estimator fast estimation active
25 1 = Acceleration torque instantaneous in the I/f mode
26 Reserved
27 Reserved
28 Reserved
29 Reserved
30 Reserved
31 Reserved
3 4
Factory setting
1 [6040.3]
0 [6040.5]
0 [6031.2] [6031.6]
0 [6031.1] [6031.6] [6031.7]
1 [6040.3]
0 [6050.6]
0 [6030.7] <1>
0 [6031.1] [6031.6]
0 [6060.4]
1 [6030.6] <1>
0
<1> 0
0
0
0
0
<1>
0
<1>
0
<1>
0
<1>
5 6
Function diagram
fp_6490_51_eng.vsd
SINAMICS
14.05.20 V05.02.03
p0115[1] (Motor Modules)
7 8
- 6490 -