MASCHIO GASPARDO SC PRO 230 Uso Y Mantenimiento página 68

ENGLISH
10.1 MAINTENANCE PLAN - Summary table
INTERVAL
WHEN THE MACHINE lS NEW
EVERY 8 WORKING HOURS
EVERY 50 WORKING HOURS
EVERY 400 WORKING HOURS
EVERY FIVE YEARS
REST PERIODS
It is in the interests of the user to follow these instructions carefully, as when work recommences, he will fi nd the equipment in perfect
condition.
OIL QUANTITY (l.)
1)
2)
2
1)
1
Fig.61
68 - EN
USE AND MAINTENANCE
- Grease all parts indicated by transfer nr. 14 ('GRASE') at page 45 of this leafl et.
- After the fi rst hours of work check that all the bolts are still tight.
- Grease the cardan shaft cross journals.
- Check that the bolts fi xing the hoe blades are well tightened.
- Grease the roller supports if the rear roller is installed.
- Check the state of wear and the integrity of the tractor connecting elements and of the
structural elements. The machine cannot be used if anomalies are noted. Contact your
dealer immediately
- CHANGE THE OIL IN THE GEARBOX HOUSING AFTER THE FIRST 50 HOURS.
- Check the level of the oil in the gearbox (1 Fig.61) and top up to the level mark on the rod
as necessary (2 Fig.61)
- Check the level of the oil in the rotor splindle cover (7 Fig.61) and top up through the oil fi ll
plug as necessary (8 Fig.61)
- Grease the cardan shaft cross journals.
- Side transmission gears: check the level of the oil in the side casing of the transmission unit,
unscrewing the level plug (3 Fig.61) and checking that oil fl ows out. Add oil through the fi ll
plug if necessary (4 Fig.61). It should fl ow from the level plug.
- Change the oil in the in the gearbox and transmission casing by completely draining off the
old oil through the drain plug under the reduction unit (5 Fig. 36) and through the transmission
drain plug (6 Fig.61).
- When this operation is carried out, it is also advisable to demount and clean the clutch disks
and and check the tightness of the clutch springs (if the cardan shaft has a clutch).
- Check that all bolts are well tightened.
- Replace all the tubes of the hydraulic systems.
At the end of the season, or if a long period of rest is foreseen it is advisable to:
1) Wash the equipment thoroughly with water, then dry them. Clean the electrical components
only with a dry cloth.
2) Carefully check for worn or damaged parts and replace then where required.
3) Firmly tighten all screws and bolts.
4) Apply protecting oil to all unpainted parts.
5) Protect the equipment with a (nylon) cover.
6) Then position it stably in a dry place out of the reach of unauthorized people
4,6
0,2
2)
5
7
TYPE OF WORK
OIL QUANTITY (l.)
3)
8
4,9
3)
4
3
6
cod. F07011998