J.P. Bowlin Sartorius Cubis II Manual página 35

Operating Design
4.8.4 Parameters in the "DEVICE/PC-USB" Menu
Parameter Settings
DAT.REC. SBI.WEIGH.
XBPI
SBI*
PC.SPREAD.
PC.TEXT
OFF
BAUD 600, 1200, 2400,
4800, 9600*,
19200, 38400,
57600, 115200
PARITY ODD*
EVEN
NONE
HANDSHK. HRDWARE
NONE*
DATABIT 7 BITS, 8 BITS*
* Factory setting
4.8.5 Parameters in the "DEVICE/USB" Menu
Parameter Settings
DEV.USED NONE*
[Device
Designation]
* Factory setting
34 Operating Instructions Cubis
Explanations
Enables a faster SBI communication, only for software commands to the
weighing module.
Extended range of commands to control numerous balance functions
with binary protocol for direct communication with the weighing module.
Enables SBI communication. The data is output to a PC or control unit.
Enables the use of ESC commands from a PC to control the basic
balance functions with ASCII protocol.
Enables data output to a spreadsheet program via a direct PC
connection.
Enables a direct PC connection to be established to a text processing
program.
Deactivates the data output.
Sets the baud rate to the selected value.
Applies an odd parity.
Applies an even parity.
Does not apply a parity.
Sets the handshake protocol to hardware handshake.
Does not set a handshake protocol.
Sets the number of data bits to the selected value.
Explanation
Indicates that no device connection is detected at the USB port.
Displays the designation of the devices connected to the USB port.
| MCE Models
®