J.P. Bowlin Sartorius Cubis II Manual página 50

1
2
1
6 Getting Started
6.1 Attaching the Connection Cable for the
Operating Display
Procedure
Insert the connection cable for the operating display into the recess in
t
the rear side of the device (2).
Plug the connection cable for the operating display into the "Operating
t
display connection" (1) and screw tightly by hand.
6.2 Connecting the Power Supply Unit
to the Device
Procedure
Plug the power supply cable into the power supply unit connection.
t
Connect the connection cable from the power supply unit to the "Power
t
supply" connection (1) on the back of the device.
6.3 Connecting the Power Supply
Procedure
Check whether the country-specific power plug matches the power
t
supplies at the installation site.
If required: Contact Sartorius Service.
t
Check whether the voltage specifications on the manufacturer's ID label
t
match those of the power supply at the installation site.
If the input voltage is too high or too low: Do not connect the device
t
to the power supply.
Contact Sartorius Service.
t
Operating Instructions Cubis
Getting Started
| MCE Models 49
®