J.P. Bowlin Sartorius Cubis II Manual página 51

Getting Started
1
2
50 Operating Instructions Cubis
Connect the device to the power supply at the installation site. To do
t
this, connect the power plug from the power supply cable into the power
socket.
The device is switched on and performs the initial functions for device
y
startup.
6.4 Connecting Accessories
Accessories can be connected to the device. For certain accessory parts,
the covers must be removed in the wall of the weighing compartment,
e.g. for connecting a sample holder module.
Requirements
The accessories must be suitable for the device (see instructions for the
accessories).
Procedure
If a cover for the rear wall of weighing compartment needs to be
t
removed from the device: Remove the top (1) and bottom (2) covers for
the rear wall of the weighing compartment from the device.
Connect the accessories to the appropriate connections on the device
t
(for connections for accessory parts, see instructions for accessories).
6.5 Attaching Protective Caps and Covers
If connections of the device are not being used during operation: We
recommend using the protective caps and covers provided to seal the
connections on the rear wall of the weighing compartment and on the back
of the device.
Procedure
Check whether all unused connections have been sealed.
t
If required: Seal the unused connections on the device using the
t
corresponding covers or protective caps.
| MCE Models
®