VM Motori MR 500 Serie Manual Instrucciones Para El Uso página 86

ENGINE OIL CHANGE
Follow the procedure below.
1 -Turn off the engine and remove the ignition key.
2 -Let the engine cool down adequately to avoid being
burnt.
3 -Prepare a container of appropriate capacity. As for the
oil quantity, see "Specifications".
4 -Unscrew the load plug (M).
5 -Unscrew the plug (Q).
6 -Insert the pump (R) and screw it to pipe.
7 -Operate manually the pump to transfer all the oil into
the container.
8 -Pour the new oil until it reaches the correct level on the
dipstick (see "Engine oil level control")
9 -Disconnect the pump.
10 -Screw again the plug (Q).
11 -Screw again the load plug (M).
12 -Start the engine and bring it to the operating tempera-
ture (70÷80 °C).
13 -Check for any oil leaks
14 -Turn off the engine and check the oil level (see "Engi-
ne oil level control").
Warning - Caution
In the event of oil leaks, check the level periodically
to evaluate the extent of the leak. If the amount is
excessive, contact a service workshop.
Important
Do not throw the oil in the environment but carry out
its disposal in compliance with legislation in force
in the country where it is used. Use the oils and
lubricators recommended by the manufacturer (see
"Recommended lubricants").
English
R
33
MR 500
GB
M
Q
Ed.4 - 02/2024