Configuration Of The Labeller; Printer Setting; Applicator Settings - Weber Legi-Air 2050 Traduccion De Las Instrucciones

Chapter 6 Installation and initial commissioning

Configuration of the labeller

DE

Printer setting

The printer (pre-)configured for the printing application operation.
The printer has a display-controlled configuration menu (*detailed information can be
found in the user manual).
The following parameters of the printer configuration are relevant for the applicator opera-
tion:
GB
Parameter
(Printing) Print Mode
(Printing) Backfeed
External I/O
(Signals) EXT 9Pin
(Signals) EXT Mode
(Signals / Inputs) Start Print
(Signals / Inputs) Reprint

Applicator settings

The applicator can be configured via DIP switches and potentiometer settings.
Version: 24.05.2016
Value
Signals
MODE 1
TYPE 3
Inputs >
< Pin 5 >
< Pin 7 >
Pos. Designation
1 [START[] BUTTON
2 [RESET[] BUTTON
3 STATUS LEDS
4 DIP-SWITCH WITH THE SWITCHES [SW1] TO [SW4]
TR1
TRIMMER POTENTIOMETER (POTI) TR1
TR2
TRIMMER POTENTIOMETER (POTI) TR2
Parameter
Dispenser
Before
Enable
>
(Signals / Outputs) Ribbon Near End
(Signals / Outputs) Qty
(Signals / Outputs) Dispenser
(Signals / Outputs) Label Near End
(Deviations are possible, depending on the printer firmware)
Page 46 of 68
40037053 BTA Legi-Air 2050
Value
Outputs >
< Pin 10 >
< Pin 9 >
< OFF >
< OFF >
Fig. 6-8: Settings on the applicator
ML-GB