Labelling Operation Stop; System Decommissioned The System - Weber Legi-Air 2050 Traduccion De Las Instrucciones

Chapter 7 Operation

Labelling operation stop

DE
Instruction
How to stop the labelling operation.
Step
GB

System decommissioned the system

The label material receives a curvature in the bend area of the deflection rollers, which
can lead to errors during the dispensing operation. This property of the labels and the de-
gree of curvature depend on the material, and can vary greatly between the different types
of print media. Ambient conditions such as high temperatures and high humidity can en-
hance the effect.
By opening the print module door, the labeller will switch to the fault mode. Turn off the
entire labeller via the mains switch.
Remove critical label stock from the labeller before longer downtimes and after the
end of work.
Version: 24.05.2016
Approach
1 Switch off the labeller (see page 52).
The dispensing tamp is powerless and may descent under the influence of
gravity depending on the installation position. A label which is present on the
dispensing tamp will no longer be held after the vacuum is switched off.
Observe the notices contained in "System decommissioning" (page 54 et
2
seq.).
In case of downtimes which last several hours, the label strip
must be removed from the dispenser.
Page 54 of 68
40037053 BTA Legi-Air 2050
ML-GB