Functions Of The Control Elements; Labelling Operation Start - Weber Legi-Air 2050 Traduccion De Las Instrucciones

Chapter 7 Operation

Functions of the control elements

The [START] button has 3 functions. It is used to:
1 - start the labelling operation.
[START]
2 - acknowledge an error message.
3 - trigger the labelling cycle (JOG function, instead of a photocell)
The [RESET]-button is accessible through an opening in the control panel. After
each change of a DIP-Switch or potentiometer - [TR1↑] and [TR2↓] position, the
[RESET]
[reset] button must be pressed to apply the new setting.
The two trimming potentiometers [TR1↑] and [TR2↓] are accessible through
[ TR1↑]
openings in the control panel of the applicator (see Fig. 7-1 on page 52). Their
adjustment can drastically affect the application behaviour and in particular the
[ TR2↓]
signal states of the labeller interface
  CD
The light-emitting diodes (in short LEDs) indicate different states of the labeller.
  CU
They are linked to the respective solenoid valves in the applicator tower and
  AB
illuminate once the respective valve is active.
 
In addition, the light-emitting diodes indicate a cause of error in case of a fault.
EJ
  AA Further details can be found in the Chapter Troubleshooting.
The four DIP-Switches [SW1], [SW2], [SW3], [SW4] are accessible through an
[SW1-4]
opening in the control panel of the labeller, and are used for the configuration of
different print-application cycles.

Labelling operation start

Prerequisites

The initial commissioning (see chapter "Installation and commissioning") has
been successfully completed.

Labeller is supplied with compressed air, power, and possibly foil and label stock.
Instruction
How to start the labelling operation.
Step
1
2
3
4
* Provided the start operations of the printer have been completed, and there are no further disturbances.
Version: 24.05.2016
Risk of crushing through tamp movement!
Approach
Switch on the labeller (see page 52).
After being switched on, the labeller switches into the Idle-Mode() and the
following text message initially appears in the display:
Risk of crushing through tamp movement!
4
Press the [Start] button on the display to enable the labelling operation.
*
Page 53 of 68
40037053 BTA Legi-Air 2050
ML-GB
DE
GB
FR
NL