Insert Labels And Ribbon; Initial Commissioning; Safety Notice - Weber Legi-Air 2050 Traduccion De Las Instrucciones

Chapter 6 Installation and initial commissioning

Insert labels and ribbon

For information on how to insert the labels and ribbon can be found in the supplied
printer manual, and as a video tutorial on the screen of the printer.
As the backing strip for the labelling operation is wound up in the Legi-Air 2050, the video
"Rewinder (winder)" applies accordingly.

Initial commissioning

Safety notice

Prerequisites

Tamp pad is drilled and installed

Full control of the product handling

One or more sample products

Print media (labels, possibly ribbon) are properly inserted (see page 51)

Labeller is connected to electricity and compressed air

Print data can be sent to the print module

Triggering of the labelling is possible via Product Detector or I/O interface
Instruction
This is how the labelling machine can be put into operation.
Step
1
2
3
4
5
4
* Provided the start operations of the printer have been completed, and there are no further disturbances.
Version: 24.05.2016
Hazards from moving parts.
RISK OF INJURY!
Catchment and crushing risk through pneumatically or electrical-
ly powered components of the labeller.
Movements or rotations start in the labelling operation suddenly
and abruptly.
̶ Do not reach into, towards or between moving parts.
Approach
Place the product onto the conveyor route at a distance of 1-2 m from the
labeller.
Switch on the labeller. Also refer to "Labeller on/off switching" in the chapter
"Operation".
RISK OF CRUSHING! Maintain an adequate distance from moving parts.
4
Press the [Start] button on the display to enable the labelling operation.
*
Depending on the system configuration the Legi-Air 2050 will execute the
printing process after the data transfer has completed.
Send print data to the printer.
Switch on the conveyor system to feed products.
Page 51 of 68
40037053 BTA Legi-Air 2050
ML-GB
DE
GB
FR
NL