Additional Display; Ambient Conditions Module; Automatic Feeder; Inputs / Outputs - RADWAG 4Y Serie Manual Del Usuario

5. Approximate the card to the transponder card reader. The program automatically displays number
of detected card in the <Card no.> box.
6. Press button to confirm and return to the weighing.

32.5. Additional Display

Communication between the weighing device and the additional display can be established via the
following ports:
•
RS 232 (COM1)
•
RS 232 (COM2)
•
TCP
Type of data displayed on an additional display is declared in <Project> variable.
Procedure – designing a variable:
1. Enter < Peripherals> submenu.
2. Select < Additional display/
keyboard is displayed.
3. Use the on-screen keyboard to insert desired value of a project, or press <
respective value from the list.
4. Press button to confirm.
Caution! The balance cooperates with RADWAG WD5/3Y additional display. In order to ensure correct
cooperation between the balance and the additional display, set {140} variable for <
parameter, next set 38400 bits/s baud rate for a port to which the additional display is connected.

32.6. Ambient Conditions Module

Ambient conditions module (THB) can be connected to the balance via COM 1 or COM 2 port. In
order to provide correct cooperation enter module's address and baud rate for the port (port settings)
to which the ambient conditions module is connected (the address and baud rate are to be found on
an ambient conditions data plate).

32.7. Automatic Feeder

Communication between the weighing device and the automatic feeder can be established via the
following ports:
•
RS 232 (COM1)
•
RS 232 (COM2)
•
Com internal.
To ensure correct cooperation with the feeder, set its address (the address and baud rate are to be
found on an automatic feeder data plate).
33.

INPUTS / OUTPUTS

Inputs are used to control balance operation. 4Y is equipped with inputs. Each input can be assigned
with the following functions or buttons:
•
Checkweighing thresholds
•
Target value
•
Profile
Project> parameter, a <Project> edit box with an on-screen
(function disabled for standard balance models)
•
Right door
•
Parameters
•
Statistics
- 166 -
> button and select
Project>