Response Format - RADWAG 4Y Serie Manual Del Usuario

IC1
IC0
K1
K0
BP
OMI
OMS
OMG
PC
BN
FS
RV
A
EV
EVG
FIS
FIG
ARS
ARG
LDS
UI
US
UG
NT
Caution:
Each command must end with CR LF characters.

39.2. Response Format

On receipt of a command, the indicator responds as follows:
XX_A CR LF
XX_D CR LF
XX_I CR LF
XX _ ^ CR LF
XX _ v CR LF
Disable automatic internal adjustment of the balance
Enable automatic internal adjustment of the balance
Lock balance keypad
Unlock balance keypad
Activate sound signal
Give available working modes
Set working mode
Give current working mode
Send all implemented commands
Give balance type
Give max capacity
Give program version
Set AUTOZERO function
Set ambient conditions state
Give set ambient conditions
Set filter
Give set filter
Set value release
Give set value release
Set last digit
Give accessible units
Set unit
Give current unit
Cooperation with PUE 7.1, PUE 10 indicators
command understood and in progress
command carried out (appears only after the XX_A command)
command understood but not accessible at this moment
command understood but max threshold is exceeded
command understood but min threshold is exceeded
- 184 -