Density Determination Kit; Assembly; Solids Density Determination - RADWAG 4Y Serie Manual Del Usuario

20.1. Density Determination Kit

Kit intended for XA balances:
Caution!
Components of density determination kit shall be stored in a box.
Weighing pans and sinker must not be put directly on a table, this might cause their damage. Weighing
pans and sinker, if not in use, must be put on an additional stand.

20.2. Assembly

XA balances

20.3. Solids Density Determination

Prior the procedure start, it is necessary to set process-related parameters:
•
Liquid type (distilled water, ethanol, other liquid with determined density)
Caution!
If the kit has been installed and -NULL- message is displayed
than load the balance with weights set (12) and zero or tare the
indication. Thus prepared balance can be used for density
determination.
- 83 -
1 Beaker base
2 Stand
3 Sinker
4 Beaker
5 Thermometer holder
6 Thermometer
7 Flexible connector for sinker
8 Hanger
Top weighing pan for solids
9
density determination
Flexible connector for weighing
10
pans
Bottom weighing pan for solids
11
density determination
12 Additional sinker
Additional stand for a set of pans
13
or a sinker
Additional set of weighing pans
for density determination
14
solids with density lower that
density of water
of