Publicidad
Idiomas disponibles
Idiomas disponibles
■
Keypad Mode and Menu Displays
Note:
• Energize the drive with factory defaults to show the Initial Setup screen. Push
–Select [No] from the [Show Initial Setup Screen] setting not to display the Initial Setup screen.
• Push
from the Home screen to show drive monitors.
• Push
to set d1-01 [Reference 1] when the Home screen shows U1-01 [Speed Reference] in LOCAL Mode.
• The keypad will show [Rdy] when the drive is in Drive Mode. The drive is prepared to accept an Up/Down command.
• Set b1-08 [Up/Down Select in PRG Mode] to accept or reject an Up/Down command from an external source while in Programming
Mode.
–Set b1-08 = 0 [Disregard RUN while Programming] to reject the Up/Down command from an external source while in Programming
Mode (default).
–Set b1-08 = 1 [Accept RUN while Programming] to accept the Up/Down command from an external source while in Programming
Mode.
–Set b1-08 = 2 [Allow Programming Only at Stop] to prevent changes from Drive Mode to Programming Mode while the drive is
operating.
Mode
User Custom Parameters
Programming Mode
Parameters
Modified Parameters/Fault Log
Drive Mode
Monitors
Auto-Tuning
Diagnostic Tools
Programming Mode
Parameter Backup/Restore
Initial Setup
◆
Mechanical Installation
WARNING
Fire Hazard. Do not put flammable or combustible materials on top of the drive and do not install the drive
near flammable or combustible materials. Attach the drive to metal or other noncombustible material. Flammable and
combustible materials can start a fire and cause serious injury or death.
CAUTION
Crush Hazard. Tighten terminal cover screws and hold the case safely when you move the drive. If the drive
or covers fall, it can cause moderate injury.
NOTICE
Do not let unwanted objects, for example metal shavings or wire clippings, fall into the drive during drive
installation. Put a temporary cover over the drive during installation. Remove the temporary cover before start-up. Unwanted
objects inside of the drive can cause damage to the drive.
YASKAWA TOMPYEULA7002A LA700 Series Installation and Operation Instruction
Figure 1.5 LED Flashing Statuses
Figure 1.6 Relation between RUN LED and Drive Operation
Table 1.6 Drive Modes, Menu Screens, and Functions
Menu Screen
Shows the User Parameters.
Changes parameter settings.
Shows modified parameters and fault history.
Sets monitor items to display.
Auto-Tunes the drive.
• Sets data logs and backlight.
• Does the Rotation Direction Trouble Shoot.
Saves parameters to the keypad as backup.
• Changes initial settings.
• Uses the Setup Wizard to set basic parameters.
[Home] to show the HOME screen.
Function
1 English
19
Publicidad
