Ecotech Italia H24 Lynx Manual De Uso página 115

H27 PANTHER DESCRIPTION OF THE REMOTE CONTROL
The illustration shows the main commands and the list contains their description and function.
S
A) Joystick lever: A proportional ("hold-to-run")
command used to move the machine forward or
backward.
B) Joystick lever: A proportional ("hold-to-run")
command used to move the machine to the right
or to the left.
Important
Proportional type: the greater the A-B command
forward movement, the greater the movement
speed of the machine will be.
C) "STOP" button: A command to inactivate the
remote control.
D) Switch: Direction control of joystick B (right/
left).
E) "AUX" switch: optional accessory activation.
Important
The AUX switch must always be in OFF position
when there is no optional accessory on the ma-
chine.
F) Switch: A command used to activate and in-
A H M
I
D C
O
P
115
N L B
F G E
Q
R
activate the cutting blades.
– Position "ON": the function is activated.
– By activating this switch, the engine revolutions
increase until the maximum.
– Position "OFF": The function is inactivated.
G) Switch: A "hold-to-run" command to adjust the
height of the cutting deck.
H) Potentiometer: a command used to adjust the
maximum movement speed of the machine.
NOTE
If speed is set at „0", the machine won't move
even if the operator uses joysticks A-B.
I) Switch: A (hold-to-run) command that regulates
the number of engine revolutions.
L) Potentiometer: A command that balances the
speed of the machine's tracks (right or left).
NOTE
Increase slightly the downstream track speed to
avoid sideways slipping when working on a slo-
EN