Ecotech Italia H24 Lynx Manual De Uso página 117

H24 LYNX DESCRIPTION OF THE REMOTE CONTROL
The illustration shows the main commands and the list contains their description
and function.
S
A) Joystick lever: A proportional ("hold-to-
run") command used to move the ma-
chine forward or backward.
B) Joystick lever: A proportional ("hold-to-
run") command used to move the ma-
chine to the right or to the left.
Important
Proportional type: the greater the A-B
command forward movement, the grea-
ter the movement speed of the machine
will be..
C) "STOP" button: A command to inacti-
vate the remote control.
D) Switch: Direction control of joystick B
(right/left)..
F) Switch: A command used to activa-
A H M
O
P
D
I
N L B
F G
R
C
te and inactivate the cutting blades.
– Position "ON": the function is activated.
– By activating this switch, the engine re-
volutions increase until the maximum.
– Position "OFF": The function is inactiva-
ted..
G) Switch: A "hold-to-run" command to ad-
just the height of the cutting deck.
H) Potentiometer: a command used to ad-
just the maximum movement speed of
the machine.
NOTE
If speed is set at „0", the machine won't
move even if the operator uses joysticks
A-B..
I) Switch: A (hold-to-run) command that
117
EN