Publicidad
Idiomas disponibles
Idiomas disponibles
uses and procedures described by the manu-
facturer.
– Pay attention to SAFETY INSTRUCTIONS,
avoid any IMPROPER USES and evaluate any
REMAINING RISKS that may exist.
– Make sure that all safety devices are correctly
installed and efficient.
– Use the machine ONLY with the original safety
SAFETY INSTRUCTIONS FOR ADJUSTMENTS AND MAINTENANCE
– Keep the machine in maximum efficiency condi-
tions and carry out scheduled maintenance ac-
cording to the frequency and procedure stated
by the manufacturer.
– A good maintenance allows to ensure perfor-
mance over time, a longer service life and a ste-
ady level of safety requirements.
– The staff in charge of routine maintenance must
own recognised skills and special capacities in
the relevant sector.
– Mark off the neighbouring zones and ensure su-
itable safety conditions to prevent access to the
work area by third parties.
– According to the type of work, wear the Perso-
nal Protection Equipment listed in "Instructions
for use" and those envisaged by laws for safety
at work.
– Carry out all operations ONLY after having sui-
tably disconnected all energy sources to work in
safety conditions.
– Carry out the operations following the procedu-
res laid down by the manufacturer within "In-
INSTRUCTIONS ON THE WORKING AREA CONDITIONS
– The operator must use the machine suitably and
ALWAYS move forward in a cautious way, in
particular on difficult terrain and very steep slo-
pes.
– It is difficult to make a complete list of all condi-
tions related to behavioural and environmental
factors that can be a cause for risks.
– Compliance with the instructions given can re-
duce but NOT remove completely the risks.
– ALWAYS adapt the forward speed of the machi-
devices installed by the manufacturer.
– Depending on the type of work to be carried out,
use the Personal Protection Equipment listed
within "Instructions for use" and those provided
for under labour laws.
– Mark off the zones around the operating area
and ensure suitable safety conditions to prevent
access by third parties.
structions for use".
– Carry out the operations ONLY with suitable to-
ols in good conditions to avoid damages to the
machine's components and parts.
– Replace SAFETY DEVICES only with original
spare parts to keep the expected safety level
unchanged.
– Using similar but not original spare parts may
lead to non-compliant repairs, altered perfor-
mances and economic losses.
– Use lubricants (oils and greases) that are re-
commended by the manufacturer or lubricants
with the same chemical-physical characteristi-
cs.
– Call the manufacturer's Technical support servi-
ce if operations that are not described within
"Instructions for use" are necessary.
– Make sure that EXTRAORDINARY MAINTE-
NANCE works are performed only by techni-
cians with a recognised experience gained in
the specific sector.
ne to the terrain conditions and take utmost care
when operating it.
– Pay attention to the overturn risk when opera-
ting on steep slopes.
– Such overturn risk increases in a sudden and
uncontrolled way if going too fast.
– Avoid any type of obstacle, especially on steep
terrain (ditches, hollows, soft areas, etc.) that
could affect the stability of the machine, genera-
ting a subsequent overturn risk.
93
EN
Publicidad
