Ecotech Italia H24 Lynx Manual De Uso página 148

CHECKING THE ELECTRICAL SYSTEM
The illustration shows the intervention points
and the description explains the procedures to
EN
be followed.
– Check the listed components.
1. Oxidation or corrosion of fuses: replace them if
necessary (see "Replacing fuses").
2. Battery status: check voltage and the conditions
of clamp connections.
If some oxidation is found, remove it and cover the
REPLACING THE FUSES
The illustration shows the intervention points
and the description explains the procedures to
be followed.
A
B
1. Place the machine on a stable and flat surface.
2. Stop the machine
3. Remove the protection carter A and cover B.
clamps with suitable grease.
3. Starter motors' cables.
4. Alternator's cables.
5. Connectors' tightening.
Caution - Warning
Call the customer care centre if wirings show
any signs of damage, worn insulating material
or anomalous heating.
4. Replace the damaged fuse with a new one ha-
ving the same characteristics.
5. Fit again cover B and carter A.
Important
!
In case of replacement, use only fuses with the
same characteristics shown in the table.
148