Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
Blades are not rotating
Tracks do not run when the
command is activated
The cutting deck does not move
up/down
The connection between the
handheld remote control and the
remote control receiver (fitted on
the machine) is interrupted while
working
Too many vibrations
Track falling off
Cause
Blade belts are too loose
Faulty blade belts
Blades are stuck by a foreign
object
Faulty electromagnetic clutch
Faulty wiring
Faulty hydraulic system
Faulty hydraulic pumps
movement belt
Faulty electric system
Faulty electric actuator
Faulty wiring
Faulty dedicated fuse
The lifting system is stuck by a
foreign object
Too much distance between
remote control and machine
Flat remote control/machine
battery
Signal interferences
Loosened fastening screws
Damaged blades
Foreign object inside the
machine
Incorrect tensioning
Foreign object inside the track
151
Solution
Call the support service
Call the support service
Remove foreign object
Call the support service
Call the support service
Call the support service
Call the support service
Call the support service
Call the support service
Call the support service
Replace the fuse
Remove foreign object
Reduce distance
Charge or replace the battery
Switch off and on the remote
control/machine
Check screw tightening
Replace blades
Remove foreign object
Carry out the track assembling
procedure See "Track
assembling/disassembling"
Remove the foreign object Carry
out the track assembling
procedure See "Track
assembling/disassembling"
EN
Publicidad
