Ecotech Italia H24 Lynx Manual De Uso página 131

TRACKS TENSIONING
The illustration shows the intervention points and the description explains the procedures to be
followed.
1. Remove cover A unscrewing the 3 screws, with
the relevant wrench supplied.
2. Loosen the locknut B.
3. Screw in the nut C by 1 turn with the supplied
wrench and make sure that the value of the
Q
A
spring assembly D (Q) matches the one shown
on the wrench. If not, repeat the operation.
4. When the value has been reached, tighten the
locknut B.
5. Fit cover A again.
C
Q
131
EN
B
D