Publicidad
Idiomas disponibles
Idiomas disponibles
ENGINE SEASONAL STORAGE UP TO 6 MONTHS
GB
IMPORTANT
thorised VM MOTORI FCA ITALY workshop.
CAUTION - WARNING
Before operating, make sure that the battery
cables are properly connected.
IMPORTANT
If the boat has been removed from the water,
provide enough water in the sea water circuit.
- Ventilate the engine compartment by means of a
bilge ventilator or by opening the bilge door.
- The fuel eventually left in the tank must be
treated with a protective liquid suitable for fuel in
table on page 14.
- Ensure the necessary supply of water in the sea
water circuit.
- To start the engine, keep a speed of 1000 / 1200
rpm until the engine operating temperature has
reached 80°C - 95°C / 176°C - 203°F.
- Stop the engine.
- When the engine is lukewarm, replace the en-
- Wash the sea water circuit following the instruc-
tions on pages 51 - 52.
- Make sure that there are no liquid leaks. Elimi-
nate any leaks.
at idle speed - spray a commercially available rust
inhibitor (e.g. Seal Rust Inhibitor) into the intake
protect the portion of the air circuit up to the turbo-
charger. Do not exceed the quantity sprayed.
English
- Drain the sea water circuit following the instruc-
tions on page 50, engine drainage and page 51,
sea water circuit washing.
-
- Clean the outside of the engine thoroughly.
Parts that show paint wear must be touched up
using the paint described in the table on page
14. Allow the paint to dry completely and apply a
commercial corrosion inhibitor spray available in
specialist stores.
IMPORTANT
Do not dump any polluting material in the en-
vironment. Carry out their disposal in compli-
ance with the relevant legislation in force.
42
MR 506
42432070F
Ed.1 - Nov. 2019
Publicidad
