Publicidad
Idiomas disponibles
Idiomas disponibles
SERPENTINE BELT
Check visually the condition of the belt and replace
it as shown in the table on page 36.
Please contact an authorised VM MOTORI FCA
ITALY workshop as soon as possible for advice or
for any further information.
For replacing the belt, contact an authorised VM
MOTORI FCA ITALY workshop.
As a guide to visual inspection, some possible
situations and related instructions are illustrated
below:
- ABRASION
Each side of the belt is polished and vitreous.
- Problem caused in operation by contact with a
foreign object - excessive belt tension - belt ten-
sioner failure.
- The belt must be replaced, the functionality of the
belt tensioner and pulleys checked; any foreign
body must be cleaned and removed.
- IRREGULAR RIB WEARING
The belt shows damage and irregularities in the
edges that can cause breakage in the tensioning
cord.
- The problem may have been caused by a body
or foreign material in contact with the belt during
operation.
The belt must be replaced; clean and check the
pulleys.
- INCORRECT INSTALLATION
The belt ribs begin to separate from the weave
of the connecting threads, until the top covering
weave is detached, if no immediate action is taken.
- The problem develops when a part of the belt
does not work perfectly aligned and housed in the
seat of each pulley.
The belt must be replaced, check the pulleys and
the alignment.
English
BELT PATH DIAGRAM
61
MR 506
42432070F
Ed.1 - Nov. 2019
GB
Publicidad
