Blackmagic Design URSA Mini Manual De Instalación Y Funcionamiento página 139

Your URSA Mini's slate is divided into 'clip' and 'project' tabs
Reel
The 'reel' indicator shows the current reel.
Your URSA Mini automatically increments reel numbers, so there is usually no need to enter this
manually. When you are moving to a new project and want to start from reel '1' again go into the
project tab of the slate and tap 'reset project data'.
Scene
The 'scene' indicator shows the current scene number, and can also show the current shot
number and type.
The number on this indicator always refers to the current scene. You can move this up and
down using the left and right arrows on either side of the scene number, or tapping the scene
number to enter the scene number editor.
The range of possible scene numbers is 1 to 9999.
By adding a letter to the scene number in the scene number editor, you can also indicate the
current shot. For example 23A would indicate scene twenty three, shot one. If you have a shot
letter added to your scene, your URSA Mini will suggest letter increments whenever you enter
the scene number editor. For example, if your current scene number is 7B, your URSA Mini will
offer '7C' as an increment suggestion.
The scene number indicator can also show information about the current shot type in the top
right corner. You can select these in the scene number editor at the right hand side of the
shot keyboard.
The shot types available are:
WS
wide shot
MS medium shot
MCU medium close up
CU close up
BCU
big close up
ECU
extreme close up
Entering Metadata 139