Blackmagic Design URSA Mini Manual De Instalación Y Funcionamiento página 195

Setup
The 'setup' menu lets you configure the PTZ source, select the language for the menus,
and select the type of SDI level return.
Select the source of PTZ commands using the PTZ source setting. You can select from
'SDI' or '9-pin', which correspond with the 'return in' SDI inputs and the 9-pin PTZ
connector on the rear of your Blackmagic Studio Fiber Converter.
This means that you can control a PTZ camera's pan, tilt and zoom on an ATEM switcher
and send these PTZ commands to your Blackmagic Studio Fiber Converter via SDI.
These commands will be sent along the SMPTE fiber cable to your Blackmagic Camera
Fiber Converter, where they will be de-embedded and output via the DE-9 serial
connector, for connection to a PTZ motorized head.
You can also connect a PTZ controller to your Blackmagic Studio Fiber Converter via
the DE-9 connector, to control a remote head at the camera end.
The settings menu page provides the option to select
'SDI' or '9-pin' as the source of PTZ commands
Operating the Studio Fiber Converter 195