Blackmagic Design URSA Mini Manual De Instalación Y Funcionamiento página 90

AC
Percentage
Battery bars
Voltage
Fiber
When using battery power, you can switch between 'voltage' and 'percentage' or 'battery bars'
power indicators by tapping the power indicator.
TIP A list of batteries that support percentage accurate power information is provided
in the 'mounting batteries' section of this manual.
Histogram
At the bottom left of your URSA Mini touchscreen, you'll see the histogram. The histogram
shows the contrast between whites and blacks along a horizontal scale.
The histogram gives you an indication of the tonal
range between shadows and highlights in your clip.
It is also a helpful tool for checking the balance of your
exposure and to prevent your highlights from clipping
The left edge of the histogram displays shadows, or blacks, and the far right displays highlights,
or whites. When you close or open the lens aperture, you'll notice the information in the
histogram moves to the left or right accordingly. You can use this to check 'clipping' in your
image shadows and highlights. If the left and right of your edges of the histogram come to an
abrupt stop rather than falling off gradually, you may be losing highlight or shadow detail.
NOTE If you don't see a histogram in the bottom left of your touchscreen, your
LCD monitor settings may be set to display 'codec and resolution.' See the 'monitor
settings' section in this manual for more information.
Displayed when your URSA Mini is plugged into mains power.
If you are using a percentage accurate battery and plate combination and
have your battery display set to 'percentage,' the indicator will display your
battery level as a percentage. At 20% charge remaining, the indicator will
turn red.
If your battery display is set to 'percentage' but your battery plate and
battery combination does not support percentage accurate battery
information, your URSA Mini will display a battery icon that drains in 25%
increments. At 20% charge remaining, the battery bar will turn red.
When your battery display is set to 'voltage,' this indicator will display your
battery's remaining voltage. When your battery drops below 12.5 volts, this
indicator will turn red. Your URSA Mini will automatically shut down once
the battery reaches 11.9 volts.
Displayed when you have Blackmagic Camera Fiber Converter attached
to your camera and are powering the camera through the SMPTE fiber
cable. If you have a an XLR power cable plugged into URSA Mini whilst the
converter is attached, the AC icon will be displayed instead.
Touchscreen Controls 90