Blackmagic Design URSA Mini Manual De Instalación Y Funcionamiento página 256

Your ATEM Switcher will display gain in dB. This corresponds to the ISO settings on your
camera in the following way:
Gain
0
6
12
18
Please note that while URSA Mini 4.6K can be set to
18dB of gain, URSA Mini 4K's maximum gain is 12dB
Shutter Speed Control
Shutter speed control is used to change your URSA Mini's shutter angle.
As with gain control, this setting is named differently due to the terminology differences
between film cameras and broadcast cameras. Functionally, however, increasing shutter speed
is exactly the same as decreasing shutter angle.
The shutter speed control is located between the color wheel and the iris/pedestal control.
Decrease or increase the shutter speed by hovering your mouse pointer over the shutter speed
indicator and clicking the left or right arrow.
Hovering your mouse pointer over the gain, shutter
speed and white balance indicators reveal arrows
you can click on to adjust their respective settings
NOTE As ATEM shutter speed control takes priority over the shutter angle selected
on your URSA Mini, your camera's shutter angle controls are disabled when connected
to an ATEM switcher.
The table below shows the available shutter speeds in shutter speed control and their
equivalent shutter angles. It's worth noting that some shutter speeds fall outside of URSA Mini's
minimum and maximum shutter angles of 11.25 and 360 degrees, respectively. If this happens,
the closest available shutter angle is used.
When your URSA Mini 4.6K or URSA Mini Pro is connected to an ATEM switcher, the shutter
speed setting will also be visible in your camera's touchscreen status display. On URSA Mini 4K
the shutter speed will not be displayed on the touchscreen, but will be visible in an URSA
Viewfinder if attached.
ISO
200
400
800
1600
Understanding Studio Camera Control 256