Ip Video; Power Specifications - Blackmagic Design URSA Mini Manual De Instalación Y Funcionamiento

The camera audio is embedded into channels 1 and 2 of the camera feed, and the 2 audio
inputs on the back of the camera fiber converter are embedded as channels 3 and 4. All 4
audio channels are also deembedded at the other end on the studio fiber converter as analog
audio outputs.
The 'audio' page in the menu of your Blackmagic Studio Fiber Converter lets you adjust the
input levels for audio sources connected to the XLR inputs on your Blackmagic Camera Fiber
Converter. For more information refer to the 'operating the studio fiber converter' section.
Once connected, you can use the XLR input assign switch to set how the XLR inputs behave
when selected as an input source. The options available are mic audio, line level audio and
AES digital audio.
If you would like to connect microphones that aren't self powered, you can enable 48V phantom
power. Move the phantom power switch to '+48V' to enable phantom power for any microphone
connected to the XLR below, or 'off' to disable phantom power.

IP Video

A connected SMPTE Fiber cable provides for a 10-Gbit IP link between your Camera Fiber
Converter and the Studio Fiber Converter. This allows all of your video and return feeds to be
IP video based using high end, visually lossless broadcast quality 10-bit video encoding and
decoding. All other connections such as talkback, tally, camera control and lens control are also
converted to low-latency IP so you get incredibly reliable performance.

Power Specifications

The Blackmagic Studio Fiber Converter provides power for Blackmagic Camera Fiber
Converter, your camera and it's accessories. A molex connector plugs into the molex socket on
your camera's rear panel to send power to your camera from the Camera Fiber Converter.
If you need to position your camera at a distance of more than 2.1 km from the broadcast truck,
and your camera and converter are not receiving enough power over the long cable run, you
can power the camera and converter locally by having the 4 pin XLR from the camera's power
supply plugged into the +12V input on your URSA Mini or URSA Broadcast. The power will be
sent through the molex connector to the Camera Fiber Converter.
The '+12V out' connector, sometimes referred to as a 'D-tap' or 'P-tap' allows you to power
accessories like an external monitor or a large box lens, with 12V DC nominal at up to 500 mA.
The 'DC out' connector provides an additional option for powering accessories like an external
monitor. A pinout table for the DC out connector is provided below.
Operating the Camera Fiber Converter 190