Blackmagic Design URSA Mini Manual De Instalación Y Funcionamiento página 212

Attaching the PL Mount
1
Gently insert the PL baffle into the center of the
lens mount and turn until it is finger tight. Use the
wide end of the baffle tool to tighten the baffle
slightly. You need just enough pressure to keep
it in place.
3
Using a 2mm Hex driver or torque wrench set to
0.45Nm, loosely turn the five mounting screws
until initial contact is made with the shoulder of
the lens mount. To access all five screws, you
will need to rotate the PL locking ring, as some
holes are obscured when the ring is either open
or closed.
NOTE When removing the PL mount, simply follow the instructions in reverse order
from step 4 to step 1. Don't forget to remove the PL baffle and store it securely with the
PL mount.
2
Carefully place the Blackmagic URSA Mini Pro
PL lens mount onto the camera body. Ensure the
pins on the PL mount for Cooke /i Technology
are located at the 12 o'clock position.
4
1
4
5
Confirm the lens mount is level and correctly
aligned, then tighten the screws in the order
shown here to an even pressure without
overtightening the screws.
Interchangeable Lens Mount
3
2
212