Aesculap
2D camera heads PV481, PV482, PV485
Button assignment in live mode
Button assignment when on-screen display is active
When on-screen display is active, the buttons are used to navigate the
menu until the menu is left.
Short press of button
up / control +
right / next level / across /
save control setting
down / control – / on
left / back a level / save
control etting
6
®
The button assignment in live mode
depends on whether a standard profile
or user profile is set.
If a user profile is set, the buttons can
be assigned individually, however the
assignment for entering the camera
control unit menu cannot be changed.
In standard profile, the buttons are
assigned as follows:
Short press of
Long press of
button
button
Not working
Open menu
Zoom
White balance
Light source on
Light source
on/off
Single frame
Video recording
image
start/stop
Long press of but-
ton
Leave the menu
Button assignment when on-screen keyboard is active
When the on-screen keyboard is active, the buttons are used to navigate
the keyboard until the keyboard is left.
Short press of button
up
right
down
left
4.
Preparation
If the following instructions are not observed, the manufacturer assumes
no responsibility for possible consequences.
Before installation and use, ensure that the:
■
electrical installations comply with the relevant technical regulations,
■
relevant regulations concerning fire and explosion protection are
observed.
Note
For the safety of the user, it is essential that the mains power cord and,
especially, the protective earth connection are intact. In many cases defec-
tive or missing protective earth connections are not registered immedi-
ately.
Risk to patient from misdirected leakage current
due to incorrect or defective earthing!
►
WARNING
Do not touch the product and patient at the
same time.
Risk to patient due to failure of a device!
►
Keep an operationally ready replacement device
on hand and if necessary change to conventional
WARNING
surgical methods.
Long press of but-
ton
Not working
Confirm/enter
Not working
Not working