Stryker 1588 AIM Manual Del Usuario página 26

N N o o t t e e - - When the ENT/Skull surgical specialty is selected, by default DRE mode is on and the
DRE Desat function is available.
2. Press the right button to activate the D D R R E E D D e e s s a a t t function. Press the button again to
deactivate the function. DRE Desat desaturates red colors on the display monitor.
When DRE Desat is on, the bar at the bottom of the button will be green.
U U s s i i n n g g t t h h e e C C a a m m e e r r a a i i n n E E N N V V M M o o d d e e
In Endoscopic Near-Infrared Visualization (ENV) mode, the camera can visualize near-infrared
light produced by the L10 LED Light Source with AIM Technology (0220-220-300). Controls for
ENV mode are accessible via the light source or the camera console touchscreen and camera
head buttons.
W W A A R R N N I I N N G G - - Before using ENV mode, be familiar with the warnings in the Warnings: ENV Mode
section of this user manual and all warnings and instructions in the light source user manual
P27006 (English) or P27009 (multilingual). Failure to follow all warnings can result in severe eye
injury to the patient or user.
N N o o t t e e - - For complete system requirements to use ENV mode, see Stryker user manual P27006
(English) or P27009 (multilingual) for the L10 LED Light Source with AIM Technology.
The ENV button will appear on the Home screen or Menu screen when the following conditions
are met:
• The camera console is connected to the L10 LED Light Source with AIM Technology
• A camera head is connected to the camera console
• The Laparoscopy Surgical Specialty is selected on the camera console
• The L10 LED Light Source with AIM Technology is connected to an AIM SafeLight
cable (0233-050-300)
• A SafeLight scope adapter is connected to the SafeLight cable (see cable user
manual P27701 for compatible adapter part numbers)
1. To enable ENV mode, ensure the light source is in Active mode. If the light source is not
Active, the camera cannot enable ENV mode.
EN 24 P29924F