Stryker 1588 AIM Manual Del Usuario página 35

Idiomas disponibles

To minimize galvanic corrosion, avoid soaking dissimilar metals in close proximity.

The device cannot withstand an automated disinfection method.

The 1588 camera heads are not autoclavable. Steam sterilizing camera heads that are not

marked A A U U T T O O C C L L A A V V E E will result in product damage.

Allow the camera head to cool before connecting it to the console. Connecting the camera

head while it is hot may result in system error.

When using Steris® liquid chemical sterilization, remove the camera head from the chamber

once sterilization is complete, or moisture may condense inside the camera head and cause

display defects.

L L i i m m i i t t a a t t i i o o n n s s o o n n R R e e p p r r o o c c e e s s s s i i n n g g

Do not cross-sterilize the device. Using multiple sterilization methods may significantly reduce

the performance of the device.

Repeated sterilization via Ethlyene Oxide or Sterrad® 100NX® can degrade the product's

cosmetic appearance.

Do not leave the device in solutions longer than necessary. This may accelerate normal

product aging.

Damage caused by improper processing is not covered by the warranty.

M M a a t t e e r r i i a a l l s s a a n n d d E E q q u u i i p p m m e e n n t t

All materials and equipment required to reprocess the camera head shall be supplied by the user

unless otherwise noted.

I I t t e e m m

A A l l l l p p h h a a s s e e s s

Gloves, eye protection,

C C l l e e a a n n i i n n g g

Enzymatic detergent

Soft-bristle brush

Reverse osmosis/

deionized water

D D e e s s c c r r i i p p t t i i o o n n

Wear protective equipment as required by the medical

facility and procedure.

Large enough to accommodate camera head without

excessive bending of cable

Used in cleaning solution to remove surgical debris

To prepare cleaning solutions

To inject detergent into hard-to-reach areas of device

To clean exterior of device or hard-to-reach areas of device

To rinse device