Stryker 1588 AIM Manual Del Usuario página 48

G G u u i i d d a a n n c c e e a a n n d d M M a a n n u u f f a a c c t t u u r r e e r r ' ' s s D D e e c c l l a a r r a a t t i i o o n n : : E E l l e e c c t t r r o o m m a a g g n n e e t t i i c c I I m m m m u u n n i i t t y y
The device is intended for use in the electromagnetic environment specified below.
The customer or the user of the device should ensure that it is used in such an
environment.
I I m m m m u u n n i i t t y y T T e e s s t t
Electrostatic
Discharge (ESD)
IEC61000-4-2
Electrical fast
transient/burst
IEC61000-4-4
Surge
IEC61000-4-5
Voltage dips, short
interruptions and
voltage variations on
power supply input
lines
IEC61000-4-11
EN 46
I I E E C C 6 6 0 0 6 6 0 0 1 1 T T e e s s t t
L L e e v v e e l l
±8kV contact
±15kV air
±2kV for power
supply lines
±1kV for input/
output lines
(if applicable)
±1kV differential
mode
±2kV common
mode
0% Ut 0.5 cycle
0% Ut 1 cycle
70% Ut 25 cycles
0% Ut 5 seconds
C C o o m m p p l l i i a a n n c c e e L L e e v v e e l l
±8kV contact
±15kV air
±2kV line to ground
±1kV for input/output
lines
(if applicable)
±1kV differential
mode
±2kV common mode
E E l l e e c c t t r r o o m m a a g g n n e e t t i i c c
E E n n v v i i r r o o n n m m e e n n t t : :
G G u u i i d d a a n n c c e e
Floors should be
wood, concrete, or
ceramic tile. If
floors are covered
with synthetic
material, the
relative humidity
should be at least
30%.
Mains power
quality should be
that of a typical
commercial or
hospital
environment.
Mains power
quality should be
that of a typical
commercial or
hospital
environment.
Mains power
quality should be
that of a typical
commercial or
hospital
environment. If the
user of the device
requires continued
operation during
power mains
interruptions, it is
recommended that
the device be
powered from an
uninterruptible
power supply or a
battery.
P29924F