Publicidad
Idiomas disponibles
Idiomas disponibles
Lavage
Pressure
Setting
Lavage Pressure Increase
Lavage Duration
Handpiece Button Latch
Other
Handpiece Joystick
3 In 1 Audio Tones
DCO-1394
Effective Date: 12-JAN-2022
Left: User Profile Suction Screen / Right: User Prorfile Speed Screen
Left: User Profile RF Screen / Right: User Prorfile Pressure Screen
Table 5: Profile Settings – Lavage
When Lavage is set to On:
Activating Flush while inflow is active will enable Lavage mode. Lavage will increase the set pressure by the "pressure increase" amount and maintain it
for the "duration." Duration begins when flush is released.
Min
Default
Max
5%
30%
100%
5s
30s
120s
Table 6: Profile Settings – Other
If Handpiece Button Latch is On:
For Non-RF Modes (Oscillate, Bone Burring, Bone Cutting, Forward, or Reverse), when the Cut/Activate button is pressed, the handpiece shall continue running
when the button is released. When a button is pressed again, the motor shall stop running.
In RF modes or when Handpiece Button Latch (non-RF modes) is Off, activation shall only continue while the button is depressed
When Handpiece Joystick Speed/Power is Selected:
The Left and Right directions on the handpiece joystick will decrease or increase the speed or power (depending on the currently selected mode), respectively.
The Up and Down directions will increase and decrease the suction set point, respectively.
When Handpiece Joystick Pressure is Selected:
The Left and Right directions on the handpiece joystick will decrease or increase the pressure respectively. The Up and Down directions will increase and
decrease the suction set point, respectively.
When Handpiece Joystick Off is Selected:
The handpiece joystick will be disabled entirely.
When 3 In 1 Audio Tones is set to On:
When using a 3 in 1 disposable device, changing modes will have a unique sound for each mode, rather than the system default beep tone.
User Profile Other Settings Screen
Description
Percentage increase by which lavage will increase the pressure setting. The increased pressure setpoint will
max out when the set point reaches 150mmHg.
Duration in seconds for which lavage is active
LBL 6028 Rev. K
Page 18 of 306
Publicidad
