Blackmagic Design BMD-TERANEXEXP12GDL Teranex Express Manual De Instalación Y Funcionamiento página 225

ACK ↵
↵
VIDEO OUTPUT: ↵
Video mode: 1080i5994 ↵
Aspect ratio: Anamorphic ↵
Video demux mode: SingleLink ↵
Video pixel format: YCbCr422 ↵
Analog output: Component ↵
↵
Retrieving Device Information
The " Teranex Device " command returns information about the connected device:
TERANEX DEVICE: ↵
↵
The server will respond with:
TERANEX DEVICE:
Model name: (displays the Teranex model name)
Software Version: (displays the checksum of the installed software release)
FPGA Version: (displays the FPGA version of the installed software release)
Protocol Commands
Align
The Align commands are available in the Teranex 3D only. They may be used to adjust the alignment
between 3D stereoscopic left and right eye signals. In the Teranex 3D LCD menus, these functions
are included in the " Camera Align " menus. Size (Zoom), Position and Trim commands are included
in this block. Other Camera Align functions, Flip and Rotation, are found in the Mode3D command block.
To use the Align commands, the Teranex 3D must be receiving left and right eye video signals and
must be in the 3D Align mode. Enter the commands below and then proceed with adjustments via
the Align commands.
MODE3D: ↵
3D mode: 3DModeAlign ↵
↵
ACK ↵
↵
MODE3D: ↵
3D mode: 3DModeAlign ↵
...
↵
Size (Zoom), Position and Trim Commands
The commands below permit you to adjust the left and right eye signals independently. For example,
the " Align pos X left: " adjusts the horizontal position of the left eye , whereas " Align pos X right: "
adjusts the horizontal position of the right eye. For example, to move the position of the left eye 20
pixels to the right enter:
ALIGN: ↵
Align pos X left: -20 ↵
↵
ACK ↵
↵
ALIGN: ↵
Align pos X left: -20.000000 ↵
Align pos X right: 0.000000 ↵
Align pos Y left: 0.000000 ↵
Align pos Y right: 0.000000 ↵
↵
デベロッパーの皆様へ
225 225