MODE3D
The MODE3D commands are available in the Teranex 3D only. See the " 3D Menu Settings " section
of this user manual for details.
Example:
MODE3D: ↵
3D MODE: 3DModeAlign ↵
↵
ACK ↵
↵
MODE3D: ↵
3D mode: 3DModeAlign ↵
3D roll left: 0 ↵
...
↵
ALIGN: ↵
Align size X left: 0.000000 ↵
Align size X right: 0.000000 ↵
...
↵
Mode, Input and Output Commands
Command
3D mode:
2D3D intensity:
2D3D depth:
3D output:
3D input:
Rotation and Tilt Commands
The commands below may be used to adjust the alignment between the left and right eye signals
of a 3D stereoscopic source. In the Teranex 3D LCD menus, these functions are part of the " Camera
Align " menu.
Rotation (Roll, Tilt and Toe-in) and Flip commands are included in this block. Other Camera Align
functions, Size, Position and Trim, are found in the Align block.
First, enter the " MODE3D: " block command, then use the " 3D mode: " command to select " 3DModeAlign "
and proceed with the adjustment commands below.
Example:
MODE3D: ↵
3D roll left: 20 ↵
↵
Command Description
Enable the 3D processing modes of the Teranex 3D.
Values are: 3DModeOff, 3DModeConvert, 3DMode2Dto3D,
3DModeAlign
Adjust the Intensity level when 3D Mode is set to
2D to 3D. Range is --40 to +40. (Default = 15)
Adjust the Depth level when 3D Mode is set to
2D to 3D. Range is -12 to +12. (Default = 0)
Select the 3D output signal format: Values are: 3DFullFrame,
3DSideBySide, 3DTopBottom, 3DLinebyLine
Select the 3D input signal format: Values are: 3DFullFrame,
3DSideBySide, 3DTopBottom, 3DLinebyLine
デベロッパーの皆様へ
232
232