Network Config - Blackmagic Design BMD-TERANEXEXP12GDL Teranex Express Manual De Instalación Y Funcionamiento

ACK ↵
↵
MODE3D: ↵
3D roll left: 20 ↵
3D roll right: 0 ↵
↵
Command
3D roll left:
3D roll right:
3D tilt left:
3D tilt right:
3D toeIn left:
3D toeIn right:
3D flip left:
3D flip right:
Network Config
Command
Friendly name:
DHCP enabled:
IP address:
Gateway:
Subnet:
Command Description
Adjust the Left Eye Z axis image rotation.
Range is -400 to +400 units. (Default = 0)
50 units = 1 degree. (1 unit = 0.02 degree)
Adjust the Right Eye Z axis image rotation.
Range is -400 to +400 units. (Default = 0)
50 units = 1 degree. (1 unit = 0.02 degree)
Adjust the Left Eye X axis image tilt.
Range is -40 to +40 units. (Default = 0)
5 units = 1 degree. (1 unit = 0.2 degree)
Adjust the Right Eye X axis image tilt.
Range is -40 to +40 units. (Default = 0)
5 units = 1 degree. (1 unit = 0.2 degree)
Adjust the Left Eye Y axis image toe-in.
Range is -40 to +40 units. (Default = 0)
5 units = 1 degree. (1 unit = 0.2 degree)
Adjust the Right Eye Y axis image toe-in.
Range is -40 to +40 units. (Default = 0)
5 units = 1 degree. (1 unit = 0.2 degree)
Flip the Left Eye image. Values are:
Off, Horizontal, Vertical, Both
Flip the Right Eye image. Values are:
Off, Horizontal, Vertical, Both
Command Description
Displays the current user-defined name assigned
to the device. Command is used to assign a new
name to the device.
Although not advised, user may enable/disable
DHCP. True = enabled; False = disabled
Displays current IP address as an integer.
Cannot be changed by the user.
Displays current gateway as an integer.
Cannot be changed by the user.
Displays current subnet mask as an integer.
Cannot be changed by the user.
デベロッパーの皆様へ
233 233