Installing Optional Blackmagic Design Fiber Optic Sfp - Blackmagic Design BMD-TERANEXEXP12GDL Teranex Express Manual De Instalación Y Funcionamiento

Installing Optional Blackmagic
Design Fiber Optic SFP
Blackmagic Teranex AV and Teranex Express have a built in optical fiber cage so you can install
an optional optical fiber SFP module. When the SFP module is installed, you can reliably
connect video signals up to 12G-SDI over longer distances than coaxial cable can provide.
Installing the optional Blackmagic Design Fiber
Optic SFP in your Teranex Express Processor
WARNING
Precautions should be taken to reduce the risk of electrostatic discharge while installing the
SFP module.
Installing or removing the Module
The Blackmagic Design fiber optic SFP module has a clasp to assist you in removing or
installing the module. The module is "hot-pluggable," meaning that it may be installed or
removed without powering down your Teranex.
The Blackmagic Design SFP supports single mode optical fiber with LC connectors. It is
bi-directional, supporting video formats up to Ultra HD 2160p60.
Blackmagic Design SFP Module
To install the Blackmagic Design SFP Module:
1 Close the clasp before inserting the SFP module.
2 Remove the cage cover from the optical module cage on the rear panel
of your Teranex.
3 Line up the SFP module with the optical module cage and slide it into the cage.
Verify that the SFP module is completely seated and secured in the cage by
firmly pushing on the SFP module.
4 If a dust protector is present on the SFP module, leave it in place until you are ready
to install your fiber optic cables.
To remove the Blackmagic Design SFP Module:
1 Disconnect all fiber optic cables from the SFP.
2 Open the clasp on the SFP module with your index finger or a small,
flat-blade screwdriver.
Installing Optional Blackmagic Fiber Optic SFP 99 99