Blackmagic Design BMD-TERANEXEXP12GDL Teranex Express Manual De Instalación Y Funcionamiento página 46

Output Mapping
Prev
Channel 1 Source
Input 1
Input 2
Input 3
Input 4
Input 5
Reset
All
Output Mapping Menu
Output Mapping
Prev
Channel 1 Source
Dolby 1
Dolby 2
Dolby 3
Dolby 4
Reset
All
Dolby 1 mapped to Output 1
Above are examples of output mapping choices.
Input Mapping Menu
Teranex 2D models have multiple audio input types including embedded SDI and HDMI audio,
plus separate analog and AES/EBU audio inputs. With only a few exceptions, which are
contained in the points listed below, you can map the audio from any of these inputs into your
Teranex 2D independent of the video source selected.
TIP Use the 'input mapping' functionality in Teranex 2D to select the audio inputs you
would like for your audio source. You can even map different audio input types to
various audio output channels for extremely flexible audio control.
‚ 'Input mapping' is available via the front panel LCD menus and the 'audio' tab in the
Teranex setup application.
‚ When audio input sources are selected, the corresponding front panel buttons
'embed', 'AES' and/or 'anlg' will illuminate to indicate that audio has been selected from
those sources.
‚ Analog audio via RCA and DB25 inputs are available simultaneously via the 'input
mapping' menu.
‚ Pressing any 'audio' input source button on the front panel will reset the 'input mapping'
menu to the default mapping configuration for that input. The current input mapping
will be lost.
‚ Pressing 'factory reset' will set the input selection to 'embed'.
‚ 'Presets' may be used to save input mapping configurations for later recall. Also, if power
is lost, the 'power on' preset will save the mapping for use when power is restored.
‚ Only one embedded audio source is available at any given time. The embedded audio
source in use is determined by your selection of SDI or HDMI video inputs.
‚ If your video source is 'anlg', you may only use the audio from the 'AES' and/or 'anlg'
input connectors. Embedded audio channels from the SDI or HDMI inputs may
not be used.
Output Mapping
Next Prev
Channel 4 Source
Input 1
Input 2
Input 3
Input 4
Input 5
Reset
All
Input 1 mapped to Output 4
Output Mapping
Next Prev
Channel 16 Source
Tone .75 kHz
Tone 1.5 kHz
Tone 3 kHz
Tone 6 kHz
Reset
Mute
All
Output 16 is muted
Output Mapping
Next Prev
Channel 13 Source
Tone .75 kHz
Tone 1.5 kHz
Tone 3 kHz
Tone 6 kHz
Reset
Mute
All
3 kHz tone mapped to Output 13
Next
Teranex Processor Settings
Next
46 46